battery isolator wiring diagram sure power

#Battery isolator wiring diagram sure power install

I'm not being a trying to be smart, but I'm just going by the SurePower brochure, rather than having a full set of installation instructions in front of me.

#Battery isolator wiring diagram sure power install

I have a SurePower Isolator that I have been meaning to install for ages.Īre you suggesting that I can ignore all the blade connectors and only use the two battery terminals? (Assuming that the whole unit is grounded with it's mounting bolts of course.)ĭianaI'm suggesting that you read the installation manual Connect the green wire from the traxide isolator to ground. Solder the blue and grey wires from the traxide isolator to the AUX battery lead from the top of the old isolator.Ħ. Solder the red and yellow wires from the traxide isolator to the MAIN battery lead from the top of the old isolator.ĥ. Don't remove the fuse box as this is more than likely an aftermarket fuse box added to distribute power from the aux battery to devices such as an air compressor, fridge, etc, and can be used again.Ĥ. Disconnect the main and aux battery leads from the top of the old isolator.ģ. Disconnect the positive terminals from both batteries.Ģ.

To fit the traxide unit, do the following.ġ. This will consist of a live feed from the ignition, so either follow the wire back to the ignition and disconnect it, or cut it in the battery box and cap it off carefully, for fear of it shorting out in the future. The spade terminals at the side just allow you to pair the batteries up while you are starting, and separates them afterwards. In your old system, the two big terminals at the top of the battery isolator connect to your main battery and auxiliary battery respectively.